The CraftWare G-code file does show some inconsistencies with respect to the Simplif圓D file in that it does not use G29 and has a too large first layer height of 0.45 mm (this is larger than you nozzle diameter of 0.40 mm, you should always limit that to about 75 % of your nozzle diameter).įor an X gantry to become unlevel/skew, there must be a mechanical issue that is causing it to miss steps/prevent advancing at one side. ![]() ![]() It is the firmware of the 3D printer that translates this Z level in movement for your 3D printer based on the layout of the machine and the firmware settings. In case multiple Z steppers are used to move the X gantry, these are usually driven by a single driver, but if they are separately controlled, even in the G-code file the instruction would be to move up Z in total, not per stepper. The slicer has no knowledge of the hardware layout of your machine (other than the build volume and gantry dimensions if properly configured), it just creates slices of the model you present which are found in the G-code file as Z movements. What you are describing is not possible as a result of changing slicers, this must be an intermittent hardware issue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |